 |
Contact Us
|
Company
|
Site Map
|
Home © 2005 Relay Specialties, Inc. All rights reserved Use of this website signifies your agreement to the Terms of Use. |
 |
Watertight - ABS Plastic Flat Lid - Enclosures
Key Features
Key Features
- Ideally suited for mounting printed circuit boards or DIN rail mounted components
- Material - General purpose ABS plastic (material carries a UL flammability rating of UL94 HB). Not recommended for outdoor use
- Color is a light gray (RAL 7035).
- Gasketed lid with two piece "tongue & groove" construction provides protection against access of oil, dust and water.
- Gasket is factory poured using high temperature U.L. listed - silicone rubber gasket material.
- Designed to meet IP 66 & NEMA 4, 4X, 12 & 13 ratings.
- Lid is secured with self captivating - M4 stainless steel machine screws (included), threaded into integral stainless steel bushings (for repetitive assembly & disassembly). All stainless steel hardware to avoid corrosion caused by dissimilar metals.
- Internal features are maximized for mounting options:
- Internal DIN rail mounting tabs - molded in all - except 1554CGY...
- Threaded (M3) integral brass inserts & or standoffs (designed for M3.5 or #6 self tapping screws) for P.C. board or inner panel mounting in all but the smallest size (1554BGY). Options vary with size
- Vertical P.C. card guides (for 1.5 mm thick P.C. boards) are molded in all but the smallest size enclosure (1554BGY)...
 |
