| Main
Category |
Time Delay Relay |
| Sub
Category |
Repeat Cycle |
| Input Voltage |
12 VAC/VDC |
| Timing Range |
1.8 - 180 min 18 |
| Mounting |
8 Pin Octal |
| Contact Configuration |
2C DPDT |
| Output Current |
10 Amp |
| Function |
Repeat Cycle |
| Type |
Dual Knob Unit |
| Compatibility |
On all units triggered by input voltage or by a control switch, do not use a solid state switch to initiate the timing sequenceproblems with leakage current could occur. On all units with a power trigger, do not use a solid state switch with leakage curre |
| Function Description |
REPEAT CYCLE (OFF Time First Followed By ON Time and Repeating) |
| Insulation Voltage |
2,000 volts |
| Life |
Mechanical: 10,000,000 operations • Full Load: 100,000 operations |
| Load (Burden) |
2 VA |
| Maintain Function Time |
(Time unit continues to time after power is removed) 0.01 Seconds for all units |
| Output Contacts |
DPDT 10A @ 240V AC/28V DC, 1/2HP @ 240V AC, 1/3HP @ 120V AC B300 & R300; AC15 & DC13 |
| Repeat Accuracy (constant voltage and temperature) |
> 2 Seconds Delay +0.1% • 0.1 - 2 Seconds Delay +2% |
| Reset Time |
On Delay/Interval/Repeat Cycle/Delayed Interval: 0.1 Seconds, Off Delay/Single Shot/Watchdog/Triggered Delayed Interval: 0.04 Seconds |
| Setting Accuracy |
Maximum Setting (Adjustable): +5%, -0% • Minimum Setting (Adjustable): +0%, -50% • Fixed Time Delay: > 2 Seconds +1%, 0.1 - 2 Seconds +5% |
| Start-up Time |
(Time from when power is applied until unit is timing) 120 & 240V units 0.05 Seconds • 12, 24 & 48V units 0.08 Seconds |
| Temperature |
12-120V Input Voltage: -28° to 65°C (-18° to 150°F) • 240V Input Voltage: -28° to 50°C (-18° to 122°F) |
| Triggering Off Delay, Single Shot or Watchdog Units |
Timing sequence must be initiated only after input voltage is applied to unit. Minimum required trigger switch closure time is 0.1 seconds. |
| Voltage Tolerance |
AC Operation: +10/-15% of nominal at 50/60 Hz., DC Operation: +10/-15% of nominal. |
